Metallized Polypropylene (PP) Capacitors in PCM 5 mm.
Capacitances from 1000 pF to 1.0 µF. Rated Voltages from 63 VDC to 1000 VDC.
High volume/capacitance ratio
Increased pulse duty from 250VDC
Very low dissipation factor
Negative capacitance change versus
Very low dielectric absorption
According to RoHS 2011/65/EU
For high frequency applications e.g.
Sample and hold
High frequency coupling and decoupling
Polypropylene (PP) film Capacitor electrodes: Vacuum-deposited Internal construction:
Solvent-resistant, flame-retardent plastic case
with epoxy resin seal, UL 94 V-0 Terminations:
Tinned wire Marking:
Colour: Red. Marking: Black. Epoxy resin seal:
range: 1000 pF to 1.0 µF
(E12-values on request)
Rated voltages: 63VDC, 100VDC, 250VDC, 400VDC, 630VDC, 800VDC, 1000VDC Capacitance tolerances:
±20%, ±10%, ±5% Operating temperature range:
-55°C to +100°C Test specifications: In accordance with IEC 60384-16 Climatic test category: 55/100/56 in accordance with IEC
Insulation resistance at +20°C: > 3 x 104 M (mean value: 1 x 105 M)
Ur = 63V: Utest = 50 V/1 min.
Ur > 100V: Utest = 100 V/1 min.
Dissipation factors at +20°C: tan
voltage: 1.6 Ur, 2 sec
Dielectric absorption: 0.05% Voltage derating:
A voltage derating factor of 1.35% per K must be
applied from +85°C for DC voltages and from
+75°C for AC voltages. Reliability: Operational life > 300000 hours
Failure rate < 2 fit (0.5 x Ur and
Pull test on pins: 10 N in direction of pins according to
IEC 60068-2-21. Vibration:
6 hours at 10...2000Hz and 0.75mm displacement
amplitude or 10g in accordance with IEC 60068-2-6 Low air density:
1kPa = 10 mbar in accordance with IEC 60068-2-13 Bump test:
4000 bumps at 390 m/sec2 in accordance
with IEC 60068-2-29.